This page contains information on how to set Email Server in the system.
1. Make sure you have .NET Framework 2.0 installed.
2. Fill in the blanks. The fields with white shading are required.
3. Click Apply to submit the setting.
4. Click Test to test current setting and verify that the connection between your Dynamsoft SourceAnywhere server and your Email server is valid.
The name of the SMTP server.
For example: smtp.dynamsoft.com.
The port of the SMTP server.
For example: 25.
My server requires authentication
Check to enable the SMTP server authentication.
The SMTP user name.
The SMTP user password.
The Email address for the receiver to send back Emails.
For example: sawstd@Dynamsoft.com
The name of the Email sender.
The time limit of a SMTP connection.
For example: 30s.
Maximum times of sending Email
The maximum failure times of sending Emails.
The SMTP server will cancel a sending Emails operation if it fails to send the email five times.
For example: 30.
Check to enable you use the SSL to encrypt the emails.
Submit your settings.
Test whether the system can be connected to the Email Server, and User name as well as password is correct.
Test whether you can receive Email from the system.
Note: